Oddball Witch Slider Easel Card
Oddball Witch rubber stamp
Scoring board and bone folder
For the card, cut:
1 piece at 4.5″ x 5.75″ (base)
1 piece at 4.25″ x 5.5″ (easel)
1 piece at 1″ x 9″ (pull tab)
1 piece at 3.25″ x 4.5″ (easel front)
For the base layer cut one piece of paper at 4-3/8″ x 5-5/8″. Adhere to the 4.5″ x 5.75″ base piece of card and set aside.
Take the 4.25″ x 5.5″ piece of card and score at 0.5″ on each side as shown. Score just the centre section at 2.75″ in between the 0.5″ score lines.
Score the 1″ x 9″ piece of card at 1″ on one end. Fold the 1″ section over the front of the card as shown and glue down.
Stamp the sentiment from Oddball Witch onto a piece of card, cut to fit inside the frame, mat with black card, then adhere in front of the open easel using 3D foam tape. This will hold the easel open.
Decorate the easel front then adhere Oddball Witch using foam tape/dots.
Trim down the 1″ x 9″ piece of card and create a pull tag using a die, or embellishment cut from papers.