Sandie is back with another amazing tutorial today! Follow along below to recreate her gorgeous Mochi Donut Girl Lift the Flap Card!
Lift the Flap Card
Happy Sentiment Die (retired)
Designer paper (used: P13, Sugar & Spice)
Stitched rounded rectangle dies
Place a 5″ x 3.5″ rounded rectangle die into the centre of a 6×6 piece of designer paper and run through a cutting machine until almost to the top of the shoulders. Do not cut over the end of the die.
Score across the top as shown below.
This creates the lift flap.
Take a contrasting 6×6 piece of paper and cut the same sized rounded rectangle from the centre.
Adhere over the piece with the flap, bringing it up about 1/8″ so that the flap can open freely.
Apply adhesive to the back of the window piece and adhere down over the image. Stamp the sentiment in the left top corner.
Trim down to approx. 4.5″ x 5-5/8″ and mat onto a card layer, leaving a 1/8″ border all around.
Add another layer of teal/mint paper/card behind the white layer, then finally adhere to a card base.
Cut a piece of paper using a small rectangle die. Score and fold in half to make a pull tab.
Adhere the pull tab to the bottom of the flap. Add a sentiment to the front flap.