GIFT CERTIFICATE!

Treat someone special to a Stamping Bella

Click to continue

It’s Thursday with Sandiebella!

Hiya sistahs, happy Thursday-with-Sandiebella!

Today Sandiebella teaches us how to make a beautiful 
Card and gift box set featuring our BRAND NEW THE Gnome and the mistletoe rubber stamp.  Look at that pucker!
This set is simple to make and so pretty to display or give to a loved one.. especially for the holidays!

Supplies:
Cardstock
Designer papers (used: Maja Designs)
Stitched Circle, Stitched Pennants, and Stitched Hills Border Dies
Scoring board and bone folder
Adhesives and foam tape/dots
Magnets
How to:
Stamp 1 Gnome for the box, and 1 for each card you are putting into the box, onto white card and colour using your preferred medium. Fussy cut around the outline and set aside.

For the box base cut one piece of card measuring 8″ x 8.5″ and one piece measuring 4″ x 8″

Score the 8″ x 8.5″ at 5.5″ and 6.5″ on the long side and 1″, 2″, 6″ and 7″ on the short side.

Score the 4″ x 8″ piece at 5″ and 6″ on the long side.

Cut away the outer 3 sections of each corner on the 8″ x 8.5″ piece, as shown. Cut the remaining 1″ section horizontally and taper each side of it. Repeat this on both sides.

Round the edges of the 2″ section at the bottom.

Take the 4″ x 8″ piece and round the edges of the 5″ section. This is the front flap.

On the 4″ x 8″ piece, cut a tiny sliver of card on each side of the 2″ section, up to the score line. This ensures it will fit neatly in between the score lines of the larger piece.

Adhere the 2″ section to the inside top of the larger piece of card.

Front bottom, front top and back of box:

Cut one piece of white card measuring 4-7/8″ x 3-7/8″ (front top), another at 1-7/8″ x 3-7/8″ (front bottom), and another at 5-3/8″ x 3-7/8″ (back) Cut paper measuring 4.75″ x 3.75″ (front top), 1.75″ x 3.75″ (front bottom), and 5.25″ x 3.75″ (back). Round the edges at the bottom of the front top pieces and the top of the front bottom pieces. Adhere the paper to the card.

Inside:
Cut paper pieces measuring 5-3/8″ x 3-7/8″, 5-3/8″ x 7/8″ (2), and 3-7/8 x 7/8″. Adhere as shown.
Outside:
Adhere the back panel in the centre.
Also cut white card for the four sections around the centre measuring 5-3/8″ x 7/8″ (2) and 3-7/8 x 7/8″ (2). Cut paper at 5.25″ x 0.75″ (2) and 3.75″ x 0.75″ (2). Adhere the paper to the card and adhere them to the box base.
For the two outer long sections, cut paper pieces measuring 5-3/8″ x 7/8″ (2). Adhere as shown.

Apply adhesive to the outside of the 1″ tabs and adhere them to the inside of the adjacent long section to make a box shape.

Apply adhesive to the inside of the bottom 2″ section, only to the width of the side sections. Fold up the bottom and adhere to the sides, ensuring all angles are square.

If your magnets are not self-adhesive, apply a glue dot to one and adhere in the centre of the 2″ bottom section, approximately 0.75″ down.

Apply a layer of double sided tape over the magnet to secure it further.

Adhere the paper/card panel over the magnet, then place the other magnet sitting on it. Apply a glue dot to the top of the second magnet, fold down the top front of the box and adhere the magnet to it. Again, place a strip of double sided tape over the magnet to ensure it stays in place.

Cut a piece of paper measuring 4-7/8″ x 3-7/8″, round the top corners, and adhere over the magnet.

Adhere the front outside panel.

For the box and each card:

Cut stitched circles measuring 3.75″ (red card) and 3.5″ (paper), and cut 2 long stitched pennants – one from red card and one from contrasting paper.

Use the stitched hills border dies and white card to make snow drifts and adhere to the bottom of the stitched circles.

Adhere one of the circles to the box front using foam tape and then adhere the pennants as shown.

Finally, adhere the Gnome to the circle panel.
The matching card measures 3-7/8″ x 5.25″.
Card base: 3-7/8″ x 10.25″ – scored at 5.25″
White panel: 3-3/8″ x 5″ – embossed at 1/8″ on all sides
Patterned paper: 2.5″ x 3-3/8″
Sentiment strip: 3.25″ x 0.75″
The circles panel and sentiment strip have been adhered using foam tape.

Share your personal favourite Stamping Bella creations with us. We LOVE to see what you’ve been creating with Stamping Bella stamps. Share a link to your latest Stamping Bella card in the comments below, or an old favourite you made a while ago. Tell us what your favourite stamps are. Are there any additions you would like to see to the range? Let us know!

Another way to connect is by joining us in the Stamping Bella Sistahood Facebook Group and share your pictures.

If you are posting your images online, we would love to see them on Instagram and all the platforms mentioned above. To make it easier for us to find you just use #stampingbella as a hashtag. Even better tag me @stampingbella . We love it when you connect, so don’t be shy!

Until next time, HAPPY STAMPING!

MWAH

 

Post navigation

Leave a comment

Your email address will not be published. Required fields are marked *