Cut a piece of card measuring 12″ x 7″ and score on the 12″ side at 3″, 4.5″, 7.5″ and 9″

Using a pencil, mark at the 1.5″ and 10.5″ top and bottom of the 12″ side.

Make a mark at 3 1/2″ on both short sides.

Using a ruler as a guide, lightly trace from the 1 1/2″ and 10 1/2″ marks to the 3.5″ center marks on each end to create the diamond shapes.

Cut the corner areas away to create the diamond shapes on both ends.

Score another line from the top outside corner, diagonally, to the bottom of the inside scoreline. All three scorelines should intersect at the centre.

Fold the straight scoreline valley, and the diagonal scorelines mountain.

Fold the card closed, and once again use your bone folder to get a nice sharp line.

Repeat on the other end of the card base.

Cut 4 pieces of patterned paper measuring 6 7/8″ x 2 7/8″.

Cut one of them diagonally.

Lay one side of the patterned paper on the inside panel as shown, and use a pencil to mark the centre. Cut from the centre outwards to make a triangle. Keep the smaller triangles for the valley fold sections.

Repeat on the other end, using the second piece of the patterned paper. Again , keep the smaller triangle for the valley fold section.

To make two more small triangles, take another one of the 6 7/8″ x 2 7/8″ pieces and cut diagonally. Use one of the small triangles previously cut as a template to measure them.

To make the diamond panels, take the remaining 6 7/8″ x 2 7/8″ pieces and mark the cutlines using the card base as a guide.

Score all the small triangles down the middle.

Adhere the panels down, creasing the middle of the small triangles with a bone folder.

Fold the card and crease all the scorelines again.

This is how it should look now.

Stamp and colour up Uptown Girl Zodiac Virgo using your preferred medium.

Cut out using the coordinating CUT-IT-OUT Die, or fussy cut with a scissors.

Stamp the large sentiment onto white card and cut out in the shape of a tag.

Cut a piece of patterned paper 4 3/8″ x 2 7/8″ and a piece of white card measuring 3″ x 4.25″. Adhere them together. Apply a thin line of wet glue around the edges of the panel, ensuring not to apply any across the top. Adhere into the centre panel to make a pocket for the sentiment tag.

Adhere Virgo onto the front panel using 3D foam tape or dots.

Embellish the card as desired.